Jenway 6285 - Manual (Page 16)

Instrument Setup Menu
From the MAIN MENU press the down arrow key to move the highlight on the display
to cover INSTRUMENT SETUP, then press the enter key. The following display will
be shown:
EXIT
- allows the user to return to the previous menu
LOCKED - when enabled, prevents access to set up menus without the PIN code
(settings of current method to be viewed but not changed). Calibrations can still be
performed when the instrument is locked.
LOCKING CODE
- 3 digit code that must be entered to unlock the instrument
LANGUAGE - choice of English, French, German, Italian and Spanish
TIME
- set to time stamp readings and calibrations
DATE – set to date stamp readings and calibrations
DATE FORMAT - DD/MM/YY or MM/DD/YY (If the date format is changed to
MM/DD/YY the changes are reflected straight away). Used to identify saved/printed
results
OPERATOR ID
– 3 digit code can be entered from 000 to 999
Filter Status Menu
This menu provides a summary of the current method wavelength setting and
excitation and emission filters.
From the MAIN MENU press the down arrow key to move the highlight on the display
to cover FILTER STATUS, then press the enter key. The following display will be
shown:
EXCITATION
- wavelength in nm of current excitation filter
METHOD SETTING - wavelength in nm set in MEASURE SETUP menu
FILTER TYPE - 3 types of filter are available: BP = Bandpass,
COL
= Cut-Off Longpass and NPB = Narrow Bandpass
PART NO - Jenway part number of filter module
EMISSION - wavelength in nm of current emission filter
METHOD SETTING - wavelength in nm set in MEASURE SETUP menu
FILTER TYPE
- 3 types of filter are available: BP = Bandpass,
COL = Cut-Off Longpass and NPB = Narrow Bandpass
PART NO - Jenway part number of filter module
EXIT - allows the user to return to the previous menu
(13)