Jenway 6285 User Manual
Page 24
16. The method is now fully set and will be the available in the MEASURE
screen.
Section 7
Using a stored method
1. From the MAIN menu, select the SETUP menu and then MEASURE
SETUP
.
2. By setting the METHOD ID to the appropriate number (0-19) the saved
parameters such as the method name and wavelengths will appear and
be ready for use.
3. EXIT the setup menus and return to the MAIN menu.
4. Ensure that the excitation and emission filters, appropriate to selected
method, are fitted in the sample chamber.
5. Enter the MEASURE mode.
6. The name of the selected method will be shown at the top of the screen,
with the PMT gain % as set for that method also displayed. Note: This
option is not available on the Model 6270.
7. No concentration will be shown as no measurement has been taken, but
the selected units of measure will be displayed.
(21)