KANOMAX 3910 Portable Particle Counter Software Manual - Manual (Page 16)

15
4. Scheduler Software
(3) To create a new measurement point click the place on the MAP where you wish to add a location.
Then the “Edit Location” window will
open.
NAME:
Enter a Location Name.
Position:
The coordinates that you clicked are
displayed. You can edit these.
ADDITIONAL INFO:
Click on [Ref] to select an image file
for ADDITIONAL INFORMATION.
The image format should be *.jpg or *.bmp.
[Zoom] button:
Magnifies the image that was loaded in ADDITIONAL INFO.
After you complete editing, click on [OK] or [Cancel].
Click [OK] to save the edited settings.
Click [Cancel] to discard the edited settings.
Repeat this procedure to add a Location.
You can set up to 100 Locations.
(4) To edit an existing Location, select the Location that you want to edit from the Location Information
list, and click [Edit]. The “Edit Location” window will be displayed and you can edit the Location
settings.
(5) To delete an existing Location, select the Location that you want to delete from the Location
Information list, and click [Delete].
(6) To delete all Locations, click [Clear].
(7) When you finish editing the Schedule, click [Save].
4.4.2. Editing an existing file
(1) Click [File] -> [Open], or click [Open].
(2) The “Open Schedule” window will open. Select the
Schedule file that you want to edit and click [OK].
(3) Refer to steps (3) - (7) in 4.4.1 Creating a new file for
more information on editing a file.