ADTRAN 600 Series - Manual (Page 25)

Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 25
© 2002, ADTRAN, Inc. Total Access 600 Series User Manual
Start Transfer
This activator is used when the configurable items in this menu are complete.
Abort Transfer
Use this activator to cancel any TFTP transfer in progress.
>Config Transfer
Sends a file containing the TA 600 configuration to a PC connected to the &5$)7 port using XMODEM protocol or
to a file on a TFTP server using the TFTP protocol. See Appendix A. Updating Total Access 600 Firmware using
XMODEM on page 54 and Appendix B. Updating Total Access 600 Firmware using TFTP on page 57 for details.
& 21),* 7 5$16)(5 also lets you save the TA 600 configuration as a backup file, so you can use the same configuration
with multiple TA 600 units. In addition, & 21),* 7 5$16)(5 can retrieve a configuration file from a TFTP server.
To support these transfers, ADTRAN delivers a TFTP program with the TA 600 called TFTP Server. You can config-
ure any PC running Microsoft Windows with this software, and store a configuration file.
Only one configuration transfer session (upload or download) can be active at a time.
Transfer Method
Displays the method used to transfer the configuration file to or from a server. XMODEM and TFTP are
supported.
Transfer Type
Only
% ,1$5< transfers are currently supported.
TFTP Server IP Address
Specifies the IP address of the TFTP server. Get this number from your system administrator.
TFTP Server Filename
Defines the name of the configuration file that you transfer to or retrieve from the TFTP server. The default
name is
WDFIJ , but you can edit this name.
Current Transfer Status
Indicates the current status of the update.
Before using 6 7$57 7 5$16)(5 , the TA 600 should have a valid IP address, subnet mask, and default
gateway (if required).
Before using & 21),* 7 5$16)(5 , the TA 600 should have a valid IP address, subnet mask, and
default gateway (if required).