ADTRAN 600 Series User Manual
Page 58
Total Access 600 Series User Manual
© 2002, ADTRAN, Inc.
Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 58
1.
Using a Telnet program,
ORJ LQ
to Total Access 600.
2.
Select
6
<67(0
8
7,/,7<
8
3'$7(
)
,50:$5(
.
3.
Select
7)73 for 7
5$16)(5
0
(7+2'
.
4.
Enter into TFTP S
ERVER
IP A
DDRESS
, the IP address of the network server that was recorded
earlier.
5.
Enter into TFTP S
ERVER
F
ILENAME
, the full path name and filename of the update file that
was recorded earlier.
6.
Select
6
7$57
7
5$16)(5
! to start the update process. Enter
<
to confirm the transfer and
to set up the module to receive the TFTP upload.
When the update has successfully completed,
7
5$16)(5
&
203/(7(
displays in
7
5$16)(5
6
7$786
. The Total
Access 600 restarts immediately and resumes operation.
If an error occurs during the update, an error message will display in the
7
5$16)(5
6
7$786
field. If this occurs,
return to Step 3 and attempt the update again. If the same error occurs, contact ADTRAN Technical Support.
During the TFTP upload, various status messages display to indicate progress. The following table describes these
messages.
Perform Steps Below in the Order Listed
During the TFTP upload process, various status messages display in
&
855(17
8
3'$7(
6
7$786
to indicate progress. The table below describes these messages.
Message
Meaning
Contacting Server
Indicates communication with the TFTP network server
is trying to be established with the specified server
address in the TFTP Server IP Address field.
Beginning TFTP
Transfer
Indicates communication with the TFTP network server
has been established and the update file is being trans-
ferred between Total Access 600 and the TFTP network
server.
Completed
Indicates the Total Access 600 product successfully
received the update file.