ADTRAN 600 Series - Manual (Page 39)

Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 39
© 2002, ADTRAN, Inc. Total Access 600 Series User Manual
RFC1483 IP
Use this selection to support IP on this PVC. (These settings only take effect when RFC1483 is the
selected protocol.)
Active
This selection enables IP on this PVC.
Far - End IP Address
This is the address of the NEXT hop router on this interface.
IP netmask
This is the network mask used for this interface.
Local IP Address
This is the IP address for this PVC.
NAT
Use this menu to set up and use Network Address Translation on this interface.
N ETWORK A DDRESS
P ORT T RANSLATION
By enabling port translation, IP packets are modified
as they pass through this interface. During transmis-
sion, private addresses are translated into a single
public (NAPT) IP address. Incoming packets are
translated from the public to private address based on
the protocol port numbers. Once enabled, you must
set up NAT for use.
P UBLIC IP A DDRESS
M ODE
The port translation requires at least a single real IP
address for translating. This value can use the IP as-
signed to the interface (or assigned via layer 2 proto-
col like PPP), obtained using DHCP client, or
statically specified on this menu. If the address cannot
be learned, then it must be specified in order for the
translation to work.
T RANSLATION T ABLE Add translation entries to "fine tune" special proto-
cols or specify private addresses.
P UBLIC A DDRESS
M ODE
The public IP address used for this translation
entry can be the NAPT IP address assigned to the
link or can be specified. You specify an address to
direct packets with certain protocols to different
servers.
P ROTOCOL The upper layer protocol that is to be monitored
for translation. For TCP and UDP, a port number
must also be specified.
P UBLIC P ORT M ODE The public destination port associated with this
entry can be specified to add more control over
certain types of traffic. The default,
$ 1< 3 257 ,
covers all port types.