Configuring voice support – config, Call control, Rqiljxulqj 9rlfh 6xssruw ± &rqilj – ADTRAN 600 Series User Manual
Page 47: Doo &rqwuro, Ljxuh 9rlfh&rqilj 0hqx
Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 47
© 2002, ADTRAN, Inc.
Total Access 600 Series User Manual
Configuring Voice Support – Config
Use the
9
2,&(
&
21),*
menu to view and set the parameters shown in Figure 15.
Figure 15. Voice/Config Menu
>Call Control
The
&
$//
&
21752/
setting is used to configure the correct Voice Gateway protocol for voice signaling control be-
tween the Total Access 600 and the configured Gateway. The
&
$//
&
21752/
setting must be configured correctly
before the voice circuits will work correctly. The Total Access 600 supports Jetstream, Tollbridge, and CopperCom
Voice Gateways.
>VPI
The
93, setting is used to configure the Total Access 600 virtual path setting used to communicate with the configured
Voice Gateway.
>VCI
The
9&, setting is used to configure the Total Access 600 virtual circuit setting used to communicate with the config-
ured Voice Gateway.