KROHNE OPTISONIC 3400 EN - Manual (Page 67)

OPERATION
6
67
OPTISONIC 3400
www.krohne.com 11/2013 - 4002037702 - HB OPTISONIC 3400 -en-R02
C1.5.1 Volume flow Simulation of volume flow
C1.5.2 Velocity of sound Simulation of velocity of sound
C1.6 Information Information
C1.6.1 Sensor CPU Displays the ID of the CPU on the FrontEnd
C1.6.2 Sensor DSP Displays the ID of the DSP on the FrontEnd
C1.6.3 Sensor driver Displays the ID of the Sensor Driver on the FrontEnd
C1.6.4 Calibration date Displays the date of calibration of the sensor
C1.6.5 Serial no. Sensor Displays the serial number of the measuring sensor
C1.6.6 V no. Sensor Displays the Order number of the measuring sensor
C1.7 Linearization Linearization
C1.7.1 Linearization Compensation for errors made at different Reynolds numbers
C1.7.2 Dynamic viscosity Sets the value of the dynamic viscosity for Reynolds calculation
C1.8 Pipe temperature Temperature compensation
C1.9 Density Sets the density of the fluid
C1.10 Diagnosis
C1.10.1 Diagnosis 1 Sets the parameter to be assigned to cyclic value; none, flow speed (1-2-3),
velocity of sound (1-2-3)
C1.10.2 Diagnosis 2 Sets the parameter to be assigned to cyclic value ; none, gain (1-2-3), SNR
(1-2-3)
C1.10.3 Proc: Empty pipe Change NE107 status signal for status group "Proc: Empty pipe"
C1.10.4 Proc: Signal Lost Change NE107 status signal for status group "Proc: Signal Lost"
C1.10.5 Proc: Signal
Unreliable
Change NE107 status signal for status group "Proc: Signal Unreliable"
C1.10.6 Config: Totaliser Change NE107 status signal for status group "Config: Totaliser"
C1.10.7 Electr: IO
Connection
Change NE107 status signal for status group "Electr: IO Connection"
C1.10.8 Electr: Power
Failure
Change NE107 status signal for status group "Electr: Power Failure"
No. Function Settings / descriptions
C2 I/O
C2_ I/O
C2.1 Hardware Configuration of connection terminals. Selection depends on signal
converter version.
C2.1.1 Terminal A Sets the output associated with terminal A
Select: Off (switched off) / current output / frequency output / pulse output /
status output / limit switch / control input
C2.1.2 Terminal B Sets the output associated with terminal B
Select: Off (switched off) / current output / frequency output / pulse output /
status output / limit switch / control input
C2.1.3 Terminal C Sets the output associated with terminal C
Select: Off (switched off) / current output / status output / limit switch
C2.1.4 Terminal D Sets the output associated with terminal D
Select: Off (switched off) / frequency output / pulse output / status output /
limit switch
No. Function Settings / descriptions