KROHNE ALTOSONIC V EN - Manual (Page 36)

ALTOSONIC V
Operating Manual rev02 E 7.30850.34.00 Page 36 of 106
4.8.5 Controls menu: F6 Time window
The system time can be set in this window.
Note:
•
The system time is not the time used for making the totalisers. The time used by the totalisers is
the proces time. This time is calibrated together with the frequency output because the frequency
output uses the same processor timer in the UFP.
•
The Set Time can have a maximum deviation to System Time of ± 2 hours in one saving.
•
For very large deviation settings it is better to do the setting under DOS by commands TIME and
DATE.
• It is also possible to set the time through Modbus controls.
Description of the controls in this window:
Function keys do the controls of this window, therefore it is only possible to go back to the Main
window.
F1 : Go back to Main window
F3 : Scroll up in value at the red cursor position value
F4 : Scroll down in value at the read cursor position
F5 : Change cursor position to the left
F6 : Change cursor position to the right
F10 : Save configuration (set the desired time)