NSi Industries DZM200A - Manual (Page 5)

Press MIN to advance the time in minutes to
desired setting.
Press DAY key to advance to today’s day.
When present hour, minute and day are shown,
press ENTER.
1.1 TO MODIFY THE CLOCK
(If the unit was already running the program, then
unit will show the day of the week, hours, minutes).
Press MODE key. Display shows current time and
day with colon
NOT flashing and CLK symbol at
the bottom.
Use HOUR, MIN, and DAY key to modify or alter
the information. You must press ENTER to make
the changes effective.
2.0 TO SET DATE
If you are setting for the first time, display will
show
Press MONTH key. Display will show 010194
Advance month to desired setting.
Press DATE key to advance date.
Press YEAR key to advance to correct year.
When desired MONTH, DAY and YEAR are on
the display, press ENTER.
2.1 TO MODIFY OR CHANGE DATE
Press MODE key until display shows DATE. Use
MONTH, DATE and YEAR key to modify MONTH,
DATE, YEAR. Press ENTER.
6
DATE
3.0 DAYLIGHT SAVING TIME
This unit is already set for automatic DAYLIGHT
SAVING adjustment. If this is desired, you can
proceed to section 4.0 by pressing mode key.
Display will show
To eliminate daylight saving adjustment, press
ON/OFF key.
Display should show
Press ENTER. Daylight saving correction is delet-
ed or turned off.
4.0 SEASON DURATION SET
You can set up to four different seasons. If this is
NOT needed, you can proceed to section 5.0 by
pressing mode key.
Season durations are set by starting
MONTH/DATE and ending MONTH/DATE:
NOTE:
1.
Each season can be set for up to 364 days.
2. Any season can cross the year boundary, i.e.,
season can start in the current year and end in the
next year.
3. When any two or more seasons overlap, the high-
er numbered season has priority.
7
ON
OFF