NSi Industries DZM200A - Manual (Page 8)

Press MODE key till display shows
Unit is ready to be programmed for starting
MONTH and DATE for season 1.
Press MONTH and DATE keys to set MONTH and
DATE for starting of season 1. Press ENTER.
Display now shows
Use MONTH and DATE key to set ending MONTH
and DATE for season 1. Press ENTER.
Set the start and end for other 3 seasons if
desired.
To delete an entry, press DLETE key.
NOTE: If for any reason you set starting MONTH and
DATE and forget to set ending MONTH and DATE,
that season becomes invalid. Unit will erase the start-
ing date.
5.0 SET INDIVIDUAL HOLIDAY DATES
Press MODE key until display shows
1 SEASON
8
1 SEASON
H
NOTE:
A total of 24 individual holiday dates can be set. Each
holiday is set by MONTH and DATE. The same sched-
ule will repeat on every holiday date.
Press MONTH key to advance to desired month.
Press DATE key to advance to desired date.
Press ENTER. Now display shows
This means unit is ready to accept 2nd holiday date.
Use same procedure to set more holidays.
To delete a holiday date press the DLETE key.
Press ENTER.
6.0 SCHEDULE SET MODE
Press MODE key till display shows
In the SCHEDULE mode, the following information
is set:
1. CHANNEL selection (CH1 and CH2)
2. TIME: HOUR and MIN.
3. EVENT: ON or OFF
4. DAY: DAY or DAYS combination.
5. HOLIDAY
6. SEASON: Use SEASON key to advance or
SELCT to select SEASON in which this particu-
lar TIME, EVENT and DAYS combination is to
occur.
9
H
SCH
CH 1