NSi Industries DZS100BP - Manual (Page 8)

5. HOLIDAY MODE: Press ENTER to advance to
desired holiday. Press MONTH and DATE to modi-
fy, DEL to delete. Press ENTER.
6. SIGNAL MODE: Press SIG/SEC to modify, DEL to
delete. Press ENTER.
7 . SCHEDULE MODE: Press E N T E R to advance to
undesired schedule. Press H O U R, M I N , E V E N T
(SIG1/SIG2) to modify time settings. P r e s s
S E L C T and DAY to modify day s, holiday and/or
s e a s o n s, D E L to delete. P r e s s E N T E R after each
m o d i f i c a t i o n .
8. ASTRO MODE: Press LAT to change latitude. Press
ENTER. Press DAY and SELCT to add or delete
days in the sunset mode. Press ENTER. Press
HOUR and/or MIN to change offset time for sunset.
Press EVENT to change offset from + to –. Press
ENTER and follow the same procedure above to
modify or review sunrise settings.
9. RUN MODE: Time, day and seconds are displayed.
If today is a programmed holiday, an H (Holiday) will
be displayed steady. If today falls within a pro-
grammed season that season # will be displayed.
10.0 OVERRIDE (OVR1) (override key) is effective only
in the run mode. If the load is scheduled for
ON/OFF (non-signal timer); the present load status
will change until the next scheduled event. CH1 will
flash when the load is overridden from scheduled
event.
NOTE: If a channel is a signal timer, then the load
will turn on each time the override key is pressed
for the length of SIG 1 duration. Ch1 will flash while
the load is on. While the signal is in progress, it can
be terminated by using the override key.
EVENT (in the RUN mode) key is used to update the
load status. It will execute the last scheduled event. The
display will only show the last scheduled event. If there
is no schedule programmed, the display will show: —:—
11
NOTE:
1. If season durations are not set, they will not appear
on the schedule and astronomic mode.
2. Each season can be set up to 364 days.
3. Any season can cross the year boundary, i.e., sea-
son can start in the current year and end the next
year.
4. When any two or more seasons overlap, the higher
numbered season has priority.
Press MODE until display shows:
Press MONTH and DATE to set the starting period
of season 1 and then press ENTER. The display will
show:
Press MONTH and DATE to set the ending period
of season 1 and then press ENTER. Follow the
above procedure to set all other 3 seasons, if
desired. To delete any entry press DEL and ENTER.
NOTE: For any season to be used, the starting
MONTH, DATE and ending MONTH, DATE must be
preset.
5.0 SET INDIVIDUAL HOLIDAY DATES
Press MODE until display shows:
6
DTS100B - DZS100BP 3/8/07 9:29 AM Page 15