8301installop, Tork – NSi Industries 8001 User Manual
Page 14
TORK MODEL 8301
30 MINUTE REPEATING TIMER
SWITCH: SPDT
CONTACT RATINGS:
20 AMP 120/240VAC
3/4HP 120VAC;
1-1/2HP 240VAC
TIMING MOTOR:
120VAC 60Hz
POWER CONSUMPTION:
3 WATTS MAX.
INSTALLATION AND OPERATING INSTRUCTIONS
TO SET OPERATING TIMES: Each dial tab represents approximately 30 sec-
onds. These tabs can be tilted in and out with the fingers.
FOR OFF OPERATION: Tilt tabs outward as illustrated in figure 1.
Tilt out one tab for each 30 second period. This closes load 2
and opens load 1.
FOR ON OPERATION: Tilt tabs inward toward center of dial, as
illustrated in figure 2. This closes load 1 and opens load 2.
TO REMOVE MECHANISM FROM CASE: Press lever near case latch to
release mainplate and swing the movement out. To replace, insert mainplate pro-
jections in slots opposite latch and swing movement in until it latches.
Disconnect power at main panel prior to installing or servicing this
time switch or the equipment connected to it.
Connect in accordance with national and local electrical codes.
Supply Connections: Use gauge specified (AWG # 8-14) suitable for
75 degrees C (167 degrees F)
TORK
®
1 GROVE STREET, MT. VERNON, NY 10550 TEL: 914-664-3542
FAX: 914-664-5052
LI-576(A)
H
120VAC
N
C
L
2
NO
NC
LOAD 2
MOTOR
LOAD 1
CLOSED WITH
TAB INWARD
CLOSED WITH
TAB OUTWARD
Fig. 2
Fig. 1