Thermo Fisher Scientific Alpha COND 550 - Manual (Page 29)

Instruction Manual
Alpha-
COND 550
23
measuring range is selected to ‘0.0 to 200.0 mS/cm’.
Press
▲ or ▼ key to set the line resistance of the sensor cable
connected to the monitor.
Press ENT key to confirm your selection.
4
Reset to factory defaults: The display shows ‘nO dEF’.
Press
▲ or ▼ key to select:
nO dEF : Not default reset of the monitor. User configured values
remain active, when confirmed by pressing ENT key.
FCt dEF: Reset all settings of the monitor to factory defaults, when
confirmed by pressing ENT key.
CAL dEF: Reset all calibration settings of the monitor to factory
defaults, when confirmed by pressing ENT key.
NOTE: Refer section 6 for factory/calibration default settings
Press ENT key to confirm your selection.
- If ‘nO dEF’ was selected, the monitor reverts to Cnfg screen.
Press
▲ or ▼ key to access other setup screens or press ▲
and
▼ key simultaneously (escape) to return to measurement
mode.
- If ‘FCt dEF’ or ‘CAL dEF’ was selected, the monitor performs the
selected reset and returns to measurement mode.
Press ▲ or ▼ key to access other setup screens or press ▲ and ▼ key
simultaneously (escape) to return to measurement mode.
To exit from any intermediate steps, press
▲ and ▼ keys simultaneously
(escape). The monitor returns to the first screen configuration settings (Cnfg).