Output power 1, Output power 2, Proportional band 1 – West Control Solutions N8100 User Manual

Page 16: Proportional band 2, Reset (integral time constant), Rate (derivative time constant), Overlap/deadband

Advertising
background image

2.2.3

Output Power 1

This parameter is the current Output 1 power level. It is a “Read Only” parameter

and is not adjustable.

2.2.4

Output Power 2

This parameter is the current Output 2 power level (if Output 2 is fitted). It is a

“Read Only” parameter and is not adjustable. If Output 2 is not fitted, this

parameter display is not applicable.

2.2.5

Proportional Band 1

This parameter is the portion of the input span of the Controller over which the

Output 1 power level is proportional to the displayed process variable value. The

function of the Proportional Band 1 is illustrated in Figure 2-2.

2.2.6

Proportional Band 2

This parameter is the portion of the input span of the Controller over which the

Output 2 power level is proportional to the displayed process variable value. In

Figure 2-2, Proportional Band 2 is shown (a) with a non-zero value (Case 1 and

Case 2) - PID control, and (b) with a zero value (Case 3) - ON/OFF control.

2.2.7

Reset (Integral Time Constant)

This parameter is not applicable if Proportional Band 1 (see Subsection 2.2.5) is set

to 0 (ON/OFF control).

2.2.8

Rate (Derivative Time Constant)

This parameter is not applicable if Proportional Band 1 (see Subsection 2.2.5) is set

to 0 (ON/OFF control).

2.2.9

Overlap/Deadband

This defines the portion of the Proportional Band (Proportional Band 1 +

Proportional Band 2) over which both outputs are active (or, in the case of a

deadband, neither output is active). The function of the overlap/deadband is

illustrated in Figure 2-2. This parameter is not applicable if Proportional Band 1 = 0

or if Output 2 is not fitted. Note that, with Output 2 set to ON/OFF control (Figure 2-2

Case 3), the Overlap/Deadband parameter has the effect of moving the ON

Differential band of Output 2 to create an overlap (positive values) or a

deadband (negative values). When Overlap/Deadband = 0, the “Output 2 OFF”

edge of the Output 2 ON/OFF Differential band coincides with the point at which

Output 1 reaches 0%.

2-5

O054-2

59125

Advertising
This manual is related to the following products: