Badger Meter Turbine Flow Meters (Hydraulic Fluids) - Manual (Page 8)

Turbine Flow Sensor
Installation & Operating Instructions
Page 8 03/12 Form No. 05-TUR-UM-00194
Quad Flow Sensors
Material
Housing: 6013-T651 Anodized aluminum
Turbine Rotor: T416 Stainless steel
Rotor Supports: 6061-T6 Aluminum
Rotor Shaft: T303 Stainless steel
Bearings: 440 C Stainless steel ball bearings
Hub Cones: 6061-T6 Aluminum alloy
Retaining Rings: Steel, zinc plate
Seals: Buna N standard
Viton® and EPR optional
Magnetic Pick-up:
Body T303 Stainless Steel
Nut T303 Stainless Steel
Ports: SAE Straight thread O-ring boss, female, J1926/1;
Dimensions See Appendix, page 16
Model Number Information
Performance
Flow Accuracy: ±1% of full scale
Repeatability: ±0.2%
Pressure Rating: 5000 PSI (345 Bar) maximum,
Pressure Drop: See ∆ P charts on page 17
Turbine Response: ≤200 ms
Fluid Temperature: -4 to +300 °F (-20 to +150 °C)
Ambient Temperature: -4 to +131 °F (-20 to +55 °C)
Electrical
Magnetic Pick-up: Self-generating alternating pulse;
100 mV RMS (100 Hz) minimum.
Calibration
Flow sensors are calibrated with 0.876 specific gravity, 140
SUS (32 cSt) hydraulic oil. Standard calibration is done using
3-points and is traceable to NIST, ISO 9001/ANSI Z540-1 & MIL-
STD 45662A.
Nominal
Port Size
Flow Rate Series Model
SAE 12 1 - 15 GPM FSC-2005 F2082-ASCQ4
SAE 12 2 - 25 GPM FSC-2075 F2083-ASCQ4
SAE 16 3 - 60 GPM FSC-2100 F2084-ASCQ4
SAE 16 4 - 85 GPM FSC-2150 F2085-ASCQ4