Badger Meter MC4000 Diagnostic Test Equipment - Manual (Page 11)

oPerATIon
OPERATION
Measuring Mode
OTEE: N Any reference to the P2 pressure sensor assumes installation of the
optional pressure sensor in the system
Start the MC4000 by pressing ON OFF The MC4000 performs a self-test and
returns the version number of the firmware and the unit's serial number
Additionally the setup parameters, the battery capacity, date, time and free
memory are also available After the startup routine, the instrument automatically goes into measuring mode
Four windows divide the screen The two left windows show pressure measurements The right upper window measures the
temperature and the right lower window shows flow or the rpm Menu commands select the flow (Q) or the rpm (N) Three
dashes - - - in a window indicates the absence of a sensor A battery symbol in the lower right display corner indicates the
battery capacity
P1 bar
74.32
T °C
86.5
Q l/min
38.4
P2 bar
76.12
Function buttons MENU, ESC and SET
Pressing MENU accesses the menu commands Pressing MENU repeatedly scrolls through the menu choices If MENU is
pressed and held, menu items automatically scrolls at one second intervals
OK
ON
OFF
ESC
MENU
SE
T
OK
ON
OFF
ESC
MENU
SE
T
OK
ON
OFF
ESC
MENU
SE
T
Pressing ESC allows backwards menu steps After the third ESC press, the MC4000 exits the menu and switches to
measuring mode
Pressing SET activates tare in both P1 and P2 pressure channels:
OFFSET P1 SET Set pressure P1 to zero – Tare P1
OFFSET P1 RES Cancel the tare function – No Tare P1
OFFSET P2 SET Set pressure P2 to zero – Tare P2
OFFSET P2 RES Cancel the tare function – No Tare P2
OFFSET P1 SET
OFFSET P1 RES
OFFSET P2 SET
OFFSET P2 RES
OFFSET
OK
ON
OFF
ESC
MENU
SE
T
Page 11 Month 2014