Badger Meter MC4000 Diagnostic Test Equipment - Manual (Page 25)

MC4Con SoFTWAre
MC4000 Setup Tab
Under the Menu MC4000 tab, all instrument parameters can be set and then downloaded to the MC4000 The MC4000 also
transfers the process parameters and saved data currently displayed on this screen to the PC
Menu MC4000 Setup Menu MC4000 Setup
Exit File Com Select Info Language
Flow-RPM
File
New device File read File save
Menu MC4000 read Menu MC4000 store Menu MC4000 write
RPM
Dscale RPM
Scale RPM
Sel.Flow-RPM
Select RPM
Select Flow
Select off
New-Lin
Dscale RPM
Scale RPM
Units
US
EU
Language
Spanish
English
Backlight
Light on
Light off
Sel.Flow type
160 gpm
80 gpm
40 gpm
7 gpm
New-Lin
New-Tab
Scale P1
Scale P2
Pressure
New-Tab
Tab F1 INP
Tab F2 INP
Tab F3 INP
Tab Q1 OUTP
Tab Q 2 OUTP
Tab Q3 OUTP
Save Interval
1 s
2 s
5 s
15 s
30 s
60 s
120 s
300 s
600 s
1200 s
1800 s
2700 s
3600 s
7200 s
Threshold
SIGNAL > 10%
SIGNAL < 10%
SIGNAL > 20%
SIGNAL < 20%
SIGNAL > 30%
SIGNAL < 30%
SIGNAL > 40%
SIGNAL < 40%
SIGNAL > 50%
SIGNAL < 50%
SIGNAL > 60%
SIGNAL < 60%
SIGNAL > 70%
SIGNAL < 70%
SIGNAL > 80%
SIGNAL < 80%
SIGNAL > 90%
SIGNAL < 90%
Device
Name
Datalogger Menu MC4000 Measurement
Figure 10: Main MC4000 setup screen
Sel. Flow-RPM Select flow and rpm settings.
Select off Flow measurement display deactivated (display shows ----)
Select Flow Flow measurement is active
Select RPM RPM measurement is active
Sel. Flow type Select the flow rate for the currently connected flow sensor.
7 gpm (25 lpm) Default parameters for 7 gpm (25 lpm) flow sensor
40 gpm (150 lpm) Default parameters for 40 gpm (155 lpm) flow sensor
80 gpm (300 lpm) Default parameters for 80 gpm (300 lpm) flow sensor
160 gpm (600 lpm) Default parameters for 160 gpm (600 lpm) flow sensor
New-Lin Two point calibration for linear flow meters.
Scale Flow Scale the multiplication constant
See Two Point Flow Sensor Calibration Using the new lin Function.
Dscale Flow Scale the division constant
Page 25 Month 2014