Menu, Menu 13, Datalogger store off – Badger Meter MC4000 Diagnostic Test Equipment User Manual

Page 13: Save interval 1 s, Transients no. 1 off, Transients no. 2 off, Threshold signal >10, Backlight light off

Advertising
background image

oPerATIon

Menu

Pressing MENU opens the instrument’s programming menu Repeatedly pressing MENU also scrolls through the menu

selections available on the display The MC4000 uses     to select menu parameters and make changes Pressing

OK stores any new settings After pressing OK, the display responds with dATA STored Pressing ESC permits scrolling

backwards through the menu choices After three menu presses the display switches back into measuring mode

DATALOGGER

STORE OFF

Selection

STore oFF

Stop storing data to memory

STore on

Start storing data to memory by

pressing oK.

STore deleTe

Deletes all stored data

Set data recording intervals to one of a number of preset times

SAVE INTERVAL

1 s

Selection 1s, 2s, 5s, 15s, 30s, 60s, 120s, 300s, 600s, 1200s, 1800s,

2700s, 3600s, 7200s

Fast transients are stored in either of two individually selected memory locations Each transient contains a maximum

240,000 samples For example, with a sampling rate of 1 ms (1/1000 of a second) the memory capacity is 240 seconds in each

memory location The recording begins when OK is pressed To stop recording, press and hold OK for at least five seconds

The minimum recording time is 30 seconds The dATA STored message displays automatically by pressing OK which stops

data recording
The SHoW selection displays the stored measurements as a graphic

TRANSIENTS

NO. 1 OFF

Selection

NO 1

Show

NO 1

Start

NO 1

Delete

TRANSIENTS

NO. 2 OFF

Selection

NO 2

Show

NO 2

Start

NO 2

Delete

THRESHOLD

SIGNAL >10 %

Selection

>10%, <10%…>90%, <90%

The recording begins when the signal value is

larger than the selected level When the recording

must start at zero signal level, threshold <10% must

be selected

BACKLIGHT

LIGHT OFF

Selection

bACKlIGHT oFF

The backlight is off

bACKlIGHT on

When the backlight is set to on,

the display illuminates for 30

seconds each time any of the

buttons is pressed With the

backlight, set to on the power

consumption from the battery is

larger and reduces battery life

Page 13

Month 2014

Advertising