Milestone XProtect Enterprise 2014 - Manual (Page 145)

Milestone XProtect ® Enterprise
2014
Administrator's Manual
www.milestonesys.com 145 Advanced configuration
Name Description
Enable
Select to enable the use of email notifications, allowing you to
specify further properties.
Recipient(s)
Specify the email addresses to which the system should send email
notifications. To specify more than one e-mail address, separate the
e-mail addresses with semicolons (example: [email protected]; [email protected];
[email protected]).
Subject text Enter a subject text for email notifications.
Message text
Enter a message text for email notifications. Note that camera
information as well as date and time information is automatically
included in email notifications.
Variables
Click a link to include a variable to the notification. The options are:

Name of triggering event

Camera name

Trigger time (the time when the notification was registered)

Error text (for example, camera failure)
Ignore similar messages for:
Specify the number of seconds to ignore sending similar
notifications. This function is to ensure that you do not receive too
many notifications before you have solved the relevant problem.
Use schedule profile
Select the schedule profile you want to use. By default, you can
choose between Always On, Always Off or choose Add new... to
set up a custom schedule (see "Notification Scheduling properties"
on page 149).
Attachment Settings (email)
Specify the following attachment settings:
Component Requirement
Include images
Select the check box to include still images in email notifications.
When selected, each email notification includes one or more
attached still JPEG images.
Attached images includes images of before the incident, after the
incident and the actual incident, with the incident that triggered the
notification in the middle.
Important: If your device does not record any images while the
sending of notifications are turned on, no images are included in the
email notification you receive.