Milestone XProtect Enterprise 2014 - Manual (Page 68)

Milestone XProtect ® Enterprise
2014
Administrator's Manual
www.milestonesys.com 68 Advanced configuration
Properties available in XProtect Enterprise and XProtect Professional only:
SMS notification

Periods of time (example: Mondays from 08.30 until 17.45), shown in green:
Set up a profile
1. In the Schedule Profiles list, select Add new....
2. In the Add Profile dialog, enter a name for the profile. Names must not contain any of these
special characters: < > & ' " \ / : * ? | [ ]
3. In the top right corner of the dialog, select Set camera to start/stop on time to base
subsequent settings on periods of time or Set camera to start/stop on event to base
subsequent settings on events within periods of time.
4. In the calendar section, place your mouse pointer at a required start point, then hold down the
left mouse button, drag the mouse pointer and release at the required end point.
o You specify each day separately.
o You specify time in increments of five minutes. XProtect Enterprise helps you by showing
the time over which your mouse pointer is positioned.
If you base your schedule profile —or parts of it—on events within periods of time, remember to select
Start event and Stop event from the lists below the calendar section.
o Use the Configure events list, located below the other fields to define events that suit your
needs.
o To delete an unwanted part of a schedule profile, right-click it and select Delete.
o To quickly fill or clear an entire day, double-click the name of the day.
o As an alternative to dragging inside the calendar section, use the Start time, End time
and Day fields, then the Change Period or Set Period button as required. When using the
Start time and End time fields, remember that time is specified in increments of five
minutes. You cannot specify a period shorter than five minutes, and you can only use
times like 12:00, 12.05, 12:10, 12:15, etc. If you specify a time outside of the five-minute
intervals, such as 12:13, you will get an error message.
Configure when cameras should do what
Use the scheduling feature to configure when:

Cameras should be online and transfer video to your system.

Cameras should use speedup to use a higher than normal frame rate

You want to receive email and/or SMS notifications regarding cameras