Noby UK Noby-220iR2 2-Zone - Manual (Page 11)

Noby-220iiiiR2 Installation Manual Page 11 Software Revision1-0
- - -
LED Indications:
A steady green LED indicates that this panel is iiiinterlink enabled.
A steady red LED indicates that this panel is iiiinterlink disabled i.e. no address programmed.
The pulsing red LED indicates the programmed address number 1 to 8 of this panel.
The 8 yellow pushbutton LEDs indicate the detection of all connected panels on the iiiinterlink bus, with this
panel's LED rapidly flashing.
Procedure:
• Enter the
iiii nterlink Code .
• Allow 5 seconds for scanning - the 8 yellow pushbutton LEDs cycle around.
• Press
to seek the next available address - indicated by a rapid flashing pushbutton LED.
- OR -
• Press
to clear the address and disable this panel's iiiinterlink functionality.
• Press
to accept OR press to quit without updating the option.
• Allow 8 seconds for the system to stabilise before proceeding with other panel operations.
Note: The panel automatically kicks back to normal standby User Mode after 60s if left unattended.
Removing a Noby-220iiiiR2 panel from the iiiinterlink bus
A panel may be effectively switched offline by clearing its address as described in the above procedure.
1 2 2 2
1
2
Figure 4:
iiii nterlink
Programming
LED Display