Noby UK Noby-220iR2 2-Zone - Manual (Page 17)

Noby-220iiiiR2 Installation Manual Page 17 Software Revision1-0
- - -
Warnings & Cautions
Clean external surfaces with a damp cloth and mild detergent.
Do not use abrasives, solvents or polish.
Noby UK have taken every reasonable effort to ensure that the stainless steel facia is
delivered in pristine condition. Please inspect the facia prior to installing the product as
Noby UK cannot accept responsibility for any flaws or scratches incurred during installation.
This equipment is to be installed, serviced and maintained by a suitably qualified technical
person with the requisite knowledge of electrical and fire safety installations.
Take care not to accidentally reverse the battery connections during installation. Fuse F3
offers some protection but there is still a possibility of permanent damage to the electronic
circuitry. Such damage is identifiable to Noby UK and is not covered by the warranty.
The Noby-220iiiiR2 shall be permanently connected to the 230VAC building installation wiring
via a readily accessible disconnection device and in accordance with local wiring
regulations.
Part of the internal circuitry operates at 230VAC and presents an electrical shock hazard.
Do not attempt to open, dismantle, repair or tamper with this equipment without first
disconnecting the mains supply voltage.
The Noby-220iiiiR2 is Class-1 electrical equipment and must be earthed.
The Noby-220iiiiR2 incorporates fault monitoring of all circuits as required by the EN54
standard. It is important that fault indications are investigated at the earliest by a qualified
engineer. Failure to do so may result in loss of life.