NORD Drivesystems BU0940 - Manual (Page 14)

S7 standard modules – Supplementary manual options for NORD - Frequency Inverters
14 BU 0940 GB-3612
In addition, in the tab Parameterise of the properties window (Figure below), the "DP-Alarm-Mode" of
the DP slave must be set to "DPV1", whereby this setting is only necessary if the frequency inverter is
to be accessed in acyclic mode.
Note
If "DP-Alarm-Mode" is set on the slave, the operating mode of the DP-Master must be
set to "DPV1" under DPMode.
Fig. 3 Slave configuration, properties – Parameterisation [SK 2xxE] - PROFIBUS