NORD Drivesystems BU0130 - Manual (Page 16)

NORDAC SK DA-130E
16 techn. amendments reserved BU 0130 DE
4.5 Control of the reversing starter SK 160E
The field distributor SK DA-130E is equipped in such a
way that a reversing starter SK 160 E can be controled
via the terminal sockets I/O1. The SK 160E is an
electronic motor starter, which can be switched to both
rotational directions. The connection can be realised by
5-phase cable and a M12 terminal socket. The following
messages or supply currents are transmitted:
To activate the SK 160E, it is necessary for the Pin 2 to be guided from I/O5 (analogue/ digital output 24V) to
Pin 5 of I/O1, where the SK 160E is connected. This connection can be made with the help of a dip switch,
which is located inside the field distributor, on the board of the I/O unit. In the standard (factory setting), this
switch is turned on. It should therefore only be turned off if I/O1 and I/O5 are to be separated.
DIP switch = 1 (On) Æ Pin 2 of I/O5 (analogue/digital output 24V) connected with mit Pin 5 of I/O1
DIP switch = 0 (Off) Æ Pin 2 of I/O5 (analogue/digital output 24V) separated from Pin 5 of I/O1
SK 160E SK 130E
Pin Colour Connector Function Pin of I/O 1 Name Status LED
1 Brown [43] 24V DC 1 24V I/O
24V Ext. left
(green)
2 White [21] RUN-RIGHT 2
Output multi-
functional relay
24V
I/O 1 right
(yellow)
3 Blue [40] GND 3 GND ---
4 Black [17] OK 4 Digital input 2
I/O 1 left
(yellow)
5 Grey [22] RUN-LEFT 5
Analogue/Digital
output 24V
I/O 5 right
(yellow)