Brother HL-2170W - Manual (Page 125)

CHAPTER 2 PCL - 106
4 0
1
2
all downloaded entities
downloaded entity as temporary
downloaded entity as permanent
5 0
1
n
All cartridge/cards
the cartridge/card which has the highest priority.
the cartridge/card which has the lowest priority
 When the location value is 0, 1 and 2, it ignores the unit value (which might be set to any value). The
default value is 0, and whenever you reset the printer, the value is reset to the default value.
 The location unit setting is retained by the printer. If the printer does not send this command to change the
setting for an entity request, then it uses the currently available location units.
 The printer may set the location type and unit in order. It does not identify any invalid combinations until it
receives the inquire entity command. Hence, if the unit value is not in the correct range, it sets the unit to the
value for a proper error response to be sent when the inquire entity command is received.
8.5.3. Inquire status readback entity
ESC*s#I (27)(42)(115)#(73) <1Bh><2Ah><73h>#<49h>
 Specifies the entity type and makes the printer produce a status response for the entity identified in the status
readback location (type and unit).
Value Entity type
0 Font
1 Macro
2 User-defined
Pattern
3 Symbol set
4 Font extended
8.5.4. Entity status response
The status response for an inquire status readback entity command differs according to the type of the requested
entity.
8.5.5. Font response
Keywords returned from the printer depend on whether the printer font is a bitmap, unbound scalable or bound
scalable. Below is the list of keywords for a font request.
SELECT =
SYMBOLSETS=
LOCTYPE=
LOCUNIT=
Below is an example of a font status response for inquire status command.
Internal, bitmap, LetterGothic 16.66
Internal, unbound scalable, PcTennessee italic
Downloaded, bound scalable, Portugal
Font status:
PCL
INFO FONTS
SELECT="<Esc>(8U<ESC>(s0p16.66h9.5v0s0b130T"
SELECT="<Esc>(s1p__v1s0b4101T"
SYMBOLSETS="0D, 0I, 0N, 0S, 0U, 1E, 1F, 1G, ..."
SELECT="<Esc>(1U<Esc>(s1p__v0s0b5111T<Esc>(22X"