Pjl reset conditions, Remember these points about environments – Brother HL-2170W User Manual

Page 220

Advertising
background image

CHAPTER 5 PJL - 16

The diagram below illustrates how the environments interact and how the modified print environment is
affected.

FACTORY DEFAULT ENVIRONMENT

USER DEFAULT ENVIRONMENT

PJL CURRENT ENVIRONMENT

MODIFIED PRINT ENVIRONMENT

@PJL INITIALIZE

@PJL RESET

LANGUAGE RESET, @PJL ENTER, OR ANY LANGUAGE SWITCH

CONTROL PANEL

OR @PJL DEFAULT

@PJL SET

6.1.2.

PJL reset conditions

The result of PJL reset condition is different from that of a printer language reset (for example, ESC E).
Printer language reset loads the PJL Current Environment values into the Modified Print Environment. PJL
reset conditions load the User Default values into the PJL Current Environment, which are then loaded into
the Modified Print Environment.

PJL reset occurs on the following events.
1. Power

on

2.

UEL

command (when not between a JOB and EOJ command pair)

3.

@ PJL INITIALIZE

command

4.

@ PJL RESET

command

5.

@ PJL JOB

or EOJ command

6.

Other printer-specific events

7.

Reset from Control Panel

8.

Language specific exit command

9.

Emulation switching command

6.1.3.

Remember these points about environments

Remember the following points when you use PJL to set the printer to a desired state.
1. The current feature settings are the same as the control panel values ( or values in the remote printer

console program) when beginning a PJL job.

2. The current feature settings (Modified Print Environment) become the same as the PJL Current

Environment when the printer enters a printer language. The feature settings are modified by the printer
language command once a printer language is started. All other settings are overridden by printer
language commands.

3. The SET command changes the PJL Current Environment settings. These settings are effective until the

next PJL reset condition.

4. Control Panel settings, the remote printer console program settings or the DEFAULT command changes

the User Default Environment.

5. Printer language commands change the Modified Print Environment. These settings are effective during a

printer language job. The PJL Current Environment settings are loaded into the Modified Print
Environment by a printer language specific reset, for example, ESC E for PCL.

Advertising