Brother HL-2170W - Manual (Page 53)

CHAPTER 2 PCL - 34
 If the current cursor position is to the right of your new right margin setting, the cursor will be moved to the
new right margin.
 The factory default left and right margin settings are at the left and right edges of the logical page
respectively.
 Depending on your model, margin settings can be made from the printer's control panel (see the User
Guide).
10 REM ***** SET AND CLEAR SIDE MARGINS *****
20 ESC$=CHR$(27)
30 WIDTH "LPT1:",255
40 REM --- END OF LINE WRAP ON ---
50 LPRINT ESC$+"&s0C";
60 REM --- LEFT MARGIN SET TO 10 COLUMNS ----
70 LPRINT ESC$+"&a10L";
80 REM --- RIGHT MARGIN SET TO 70 COLUMNS ----
90 LPRINT ESC$+"&a70M";
100 REM --- PRINT "0123456789" 10 TIMES
110 FOR I=1 TO 10
120 LPRINT "0123456789";
130 NEXT
140 LPRINT
150 REM --- CLEAR SIDE MARGIN ----
160 LPRINT ESC$+"9";
170 REM --- PRINT "0123456789" 10 TIMES
180 FOR I=1 TO 10
190 LPRINT "0123456789";
200 NEXT
210 REM --- PAPER EJECT ----
220 LPRINT CHR$(12);
230 END
4.2.12. Resetting the horizontal margins
Esc9 (27)(39) <1Bh><39h>
This command resets the left and right margins to the left and right edges of the logical page respectively.
4.2.13. Setting the top margin
Esc& l#E (27)(38)(108)#(69) <1Bh><26h><6Ch>#<45h>
# stands for the distance between the top of the logical page and the top margin in rows.
 The row height is as defined by the VMI. If you subsequently change the VMI (or the line spacing) the top
margin position that you have set does not change - that is, when you specify the top margin position it
remains fixed physically until you specify a new one or reset it to a default value.
 The top margin command is ignored if you try to set a margin greater than the current length of the logical
page.
 The top margin command is ignored if the current VMI is 0.
 The factory default top margin setting is half an inch below the top of the logical page.
 Depending on your model, the top margin can be set from the printer's control panel (see the User Guide).
10 REM ******* SET TOP MARGIN TO 10 LINES *******
20 REM
30 ESC$=CHR$(27)
40 LPRINT ESC$+"&l10E";
50 LPRINT "10 LINES "
60 LPRINT CHR$(12);
70 END