Brother PC-8500 8500D User Manual
Page 173
Advertising
170
5
Always keep the machine clean.
1. Turn off the power and remove the presser
foot holder and the needle.
5
3
1
2. Loosen the screws. Using the metal disk
provided.
3. Remove the needle plate.
1
Needle plate
4. Turn the balance wheel towards you, and
align the notch of shuttle with the shelf of race
edge angle, and remove the shelf of race.
1
Notch of shuttle
2
Shelf of race
6
5
2
1
1
2
5. Take out the shuttle.
6. Remove accumulated lint and thread from the
inner shuttle and race with a brush or a
vacuum cleaner.
1
Race
2
Shuttle
7. Set the shuttle by aligning the shuttle
projection with spring of the stopper.
1
Projection
2
Spring
*
Lint and dust accumulated in the race will
sometimes cause poor stitching or
malfunction of bobbin thread sensor.
1
2
Advertising