Hp-gl/2 printing takes a long time, Replotting with hp-gl/2 jobs is not possible – Canon imagePROGRAF iPF760 User Manual
Page 104
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified
Cause
Corrective Action
The page size of the HP-GL/2 print job, as created in the
source application, is incorrect.
In the Control Panel menu, set PageSizeProcess2 or Conserve Paper to On.
The layout will be changed to the optimal layout.
(See "Menu Settings.")
→User's Guide
HP-GL/2 printing takes a long time
HP-GL/2 printing takes a long time
Cause
Corrective Action
Large print jobs with a lot of data take longer to print.
Please wait a while until printing is finished.
A job was printed when Input Resolution in the Control Pan-
el menu was set to 600dpi.
In the Control Panel menu, set Input Resolution to 300dpi and print
again.
(See "Menu Settings.")
→User's Guide
Replotting with HP-GL/2 jobs is not possible.
Replotting with HP-GL/2 jobs is not possible.
Cause
Corrective Action
The data was lost because of replot-
ting.
Data for replotting is lost after the following operations. In this case, send the print job again.
•
The memory buffer was cleared from the Control Panel.
•
The printer was turned off.
•
The printer has received a new HP-GL/2 print job.
•
Printing has been canceled
The printer stops when printing a HP-GL/2 job (the carriage stops moving)
The printer stops when printing a HP-GL/2 job (the carriage stops moving)
Cause
Corrective Action
The printer is analyzing the print job.
Please wait a while until printing is finished.
A job was printed when Input Resolution in the Control
Panel menu was set to 600dpi.
In the Control Panel menu, set Input Resolution to 300dpi and print again.
(See "Menu Settings.")
→User's Guide
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified
iPF760
Troubleshooting
HP-GL/2 problems
104