Canon imagePROGRAF iPF760 - Manual (Page 111)

"Remove paper and check pap. size"
Cause Corrective Action
A sheet has come out of the printer during printing. 1. Press the Release Lever back and remove the paper.
2.
Reload the sheet, aligning it with the guide on the right.
3.
Pull the Release Lever forward.
4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Dis-
play Screen, press the OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Sheets in the Printer.") →P.18
PaprWidth Mismatch PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu is
set to Pause or Warning, the width of the loaded roll
does not match the width specified in Fit Roll Paper
Width in the printer driver. Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
1. Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
→P.15
(See "Removing Rolls From the Roll Holder.") →User's Guide
2. Replace the paper with paper compatible for borderless printing.
(See "Attaching the Roll Holder to Rolls.")
→P.9
(See "Loading Rolls in the Printer.") →P.12
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded in
the printer, and then try printing again.
Paper size not detected. Paper size not detected.
Cause Corrective Action
Paper has been loaded askew, or warped paper has been loaded. Follow these steps to reload the roll.
1.
Push the Release Lever back.
2.
Adjust the right edge of the roll to make it parallel to the or-
ange Paper Alignment Line.
3. Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?"
is shown on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the er-
ror occurred.
(See "Loading Rolls in the Printer.") →P.12
If this error recurs after you reload the roll, remove the Roll
Holder from the printer, push the roll firmly in until it touches the
Roll Holder flange, and reload the Roll Holder in the printer.
(See "Attaching the Roll Holder to Rolls.")
→P.9
Follow these step to reload a sheet.
1. Push the Release Lever back.
iPF760 PaprWidth Mismatch
Basic Guide
Error Message
Messages regarding paper
111