End of paper feed, Rel lever is in wrong position, Borderless printng not possible – Canon imagePROGRAF iPF760 User Manual
Page 116
Cause
Corrective Action
There are sheets left on the
Ejection Guide.
(See "Loading Rolls in the Printer.")
There is a foreign object by
the Output Tray, obstructing
the Cutter Unit.
1.
Lift the Top Cover and remove the foreign object.
2.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press
the OK button.
Printing will resume, starting from the page on which the error occurred.
You are not using the printer
under the recommended envi-
ronmental conditions for the
paper.
Use the printer only where the recommended environmental conditions for the paper are met. Note that
various environmental conditions are recommended for various types of paper. For details on the recom-
mended environmental conditions for paper, see Paper Reference Guide."
(See Paper Reference Guide.)
You are using paper that is
not compatible with automatic
cutting.
1.
Specify Manual as the cutting method and use scissors or a cutting tool to cut the roll.
(See "Specifying the Cutting Method for Rolls.")
→User's Guide
For information about paper that is compatible with automatic cutting, see the Paper Reference Guide.
(See Paper Reference Guide.)
2.
Push the Release Lever back and remove the paper.
In other cases, the Cutter Unit
may be damaged.
Contact your Canon dealer for assistance.
End of paper feed.
End of paper feed.
Cause
Corrective Action
You are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge.
Release the ▲ button.
Rel lever is in wrong position.
Rel lever is in wrong position.
Cause
Corrective Action
The Release Lever is pushed back.
Pull the Release Lever forward.
Turn off the printer and wait a while before restoring power.
Borderless printng not possible.
Borderless printng not possible.
Cause
Corrective Action
The print job received specifies a
type or width of paper that is not
compatible with borderless printing.
Follow these steps to change the settings of the print job to enable borderless printing.
1.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2.
Make sure the correct printer driver for the printer is selected and try printing again.
For information on types of paper compatible with borderless printing, refer to the Paper Refer-
ence Guide.
(See Paper Reference Guide.)
Select None when you have set Detect Mismatch on the control panel to Warning.
However, note that this error may cause paper jams and affect the printing quality.
Press ▲ or ▼ to select Print With Border, and then press the OK button to continue printing. The
document will be printed with a border.
The loaded paper is a size not com-
patible with borderless printing.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Replace the paper with paper compatible for borderless printing as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing the Roll Holder from Rolls.")
→User's Guide
2.
Replace the paper with paper compatible for borderless printing.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
End of paper feed.
iPF760
Error Message
Messages regarding paper
116