Canon imagePROGRAF iPF760 - Manual (Page 112)

Cause Corrective Action
Paper has been loaded askew, or warped paper has been loaded. 2.
Load the sheet, aligning it with the guide on the right.
3.
Pull the Release Lever forward.
4. If "Not finished printing. Finish printing remaining jobs?"
is shown on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the er-
ror occurred.
(See "Loading Sheets in the Printer.") →P.18
Because the Platen is soiled with ink or other substances, the size of
the clear film cannot be detected. Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
→P.39
Insufficient paper for job Insufficient paper for job
Cause Corrective Action
The printer has received a print job longer than the amount of roll paper left
when ManageRemainRoll in the Control Panel menu is On. Press ▲ or ▼ to select Print, and then press the OK
button to resume printing.
However, the roll paper may run out during the print job
and you may not be able to print all of the document.
Press ▲ or ▼ to select Change Paper, and then press
the OK button to stop printing.
Either change the printer driver Paper Source setting or
the GL2 Settings > Paper Source setting in the printer
menu or replace the roll with a roll that has enough paper
for the print job, and then try printing again.
(See "Removing the Roll from the Printer.")
→P.15
(See "Loading Rolls in the Printer.") →P.12
This paper cannot be used. This paper cannot be used.
Cause Corrective Action
Paper smaller than the printer's minimum supported
size has been loaded. Push the Release Lever back and load paper of the correct size.
(See "Paper Sizes.")
→User's Guide
Paper has been loaded that is too small to print the test
pattern for printhead adjustment or nozzle checking. Push the Release Lever back and load unused paper of A4 size or larger. More
than one sheet may be required depending on the adjustment.
Roll printing is selected. Roll printing is selected.
Cause Corrective Action
You have attempted to print a test print sheet or
other printer status information on a roll, but no
roll is loaded. Press ▲ or ▼ to select Load Roll Paper, and then press the OK button. Load the
roll, and then print.
(See "Attaching the Roll Holder to Rolls.")
→P.9
(See "Loading Rolls in the Printer.") →P.12
To print on sheets, follow these steps.
Insufficient paper for job iPF760
Basic Guide
Error Message
Messages regarding paper
112