Insufficient paper for job – Canon imagePROGRAF iPF815 User Manual
Page 912
Cause
Corrective Action
Paper has been loaded askew, or warped paper has been loaded.
(See "Loading Sheets in the Printer.")
Because the Platen is soiled with ink or other substances, the size
of the clear film cannot be detected.
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
Insufficient paper for job
Cause
Corrective Action
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the printer menu is On and one of the following settings
is selected.
•
During HP-GL/2 printing, GL2 Settings >Paper Source in the printer menu is
set to an option other than Automatic.
•
The Media Take-up Unit is in use.
Press the Online button to resume
printing.
However, the roll paper may run
out during the print job and you
may not be able to print all of the
document.
Hold down the Stop button for a
second or more to cancel printing.
Either change the printer driver
Paper Source setting or the GL2
Settings >Paper Source setting
in the printer menu or replace the
roll with a roll that has enough pa-
per for the print job, and then try
printing again.
If you are using the Media Take-
up Unit, remove the printed docu-
ment from the Media Take-up
Unit before replacing the roll with
a roll that has enough paper for
the print job, and then try printing
again.
(See "Removing the Roll from
the Printer.")
(See "Loading Rolls in the Print-
er.")
(See "Removing Printed Docu-
ments from the Media Take-up
Unit.")
Error Message
>
Messages regarding paper
>
Insufficient paper for job
iPF815
13
896