Canon imagePROGRAF iPF815 MFP M40 - Manual (Page 31)

31
If Line Length Does Not Match
A test pattern is printed in black when you choose A:High or in magenta if you choose B:Standard/
Draft . •
To cancel printing the test pattern for adjustment, hold down the Stop button for a second or more, and
then go to step 7. •
You can also specify the adjustment value in Adjust Length in the Paper Details menu. In this case,
no test pattern for adjustment is printed. •
3
4
5
6
7
Press ▲ or ▼ to select Adjust Printer , and then press
the ► button.
Press ▲ or ▼ to select Adjust Length , and then press
the ► button.
Press ▲ or ▼ to select A:High or B:Standard/Draft , and
then press the ► button.
Press ▲ or ▼ to select Yes , and then press the OK
button.
Measure the length of the adjustment pattern. Calculate
the difference between the measured length and actual
length. Enter it as a percentage and press the OK button.
A test pattern is printed for adjustment based on the
amount of paper stretching or shrinkage. The scale bar
shows " Millimeter " in 50 mm units and " Inch " in 1 inch
units.
You can adjust the value in 0.02% increments. Press ▲ to
increase the value or ▼ to decrease it.
If the scale is printed shorter than actual size, set the
value toward the positive side; if it is printed longer, set the
value toward the negative side.
Millimeter Inch