Canon imagePROGRAF iPF815 MFP M40 - Manual (Page 7)

7
Troubleshooting
Phenomenon Cause Corrective Action
1.
2.
When printing on CAD Tracing Paper or film-
based media, choose a VacuumStrngth setting of
Standard , Strong , or Strongest . If paper still rubs
against the printhead, try raising the Printhead by
setting Head Height to Highest .
Straighten out the wrinkles or curls and reload the
paper. Do not use paper that has been printed on
previously.
Make sure the same type of paper is specified on the
printer as in the printer driver.
Make sure the same paper type is specified in the
printer driver as on the printer.
Hold down the Stop button for a second or more to
cancel printing.
Change the type of paper in the printer driver and
try printing again.
If this function is not needed, deactivate
CutDustReduct. through the printer menu.
Clean the Ejection Guide .
In Head Height , choose Automatic .
When printing on Heavyweight Coated Paper or
other paper-based media, choose a VacuumStrngth
setting of Strong or Strongest . If paper still rubs
against the printhead, try raising the Printhead by
setting Head Height to Highest .
The edges of the paper are dirty Open the Top Cover and clean the Platen . The Platen has become dirty after
borderless printing or printing on
small paper.
The paper is wrinkled or warped.
The type of paper as specified on
the printer does not match the type
specified in the printer driver.
A cut line is printed because the
function to reduce cutting dust has
been activated.
The Ejection Guide is soiled.
The Printhead is set too low.
You are printing on heavyweight
paper or paper that curls or
wrinkles easily after absorbing ink.
(→ , If Paper is Soiled)
(→"Selecting the Paper Type (Roll)," User Manual)
(→"Selecting the Paper Type (Sheet)," User Manual)
(→ , Loading Rolls in the Printer)
(→ , Loading Sheets in the Printer)
(→"Main Menu Settings," User Manual)
(→"Troubleshooting Paper Abrasion and Blurry
Images (Head Height)," User Manual)
(→"Adjusting the Vacuum Strength (VacuumStrngth),"
User Manual)
(→"Troubleshooting Paper Abrasion and Blurry
Images (Head Height)," User Manual)
(→"Adjusting the Vacuum Strength (VacuumStrngth),"
User Manual)
(→"Troubleshooting Paper Abrasion and Blurry
Images (Head Height)," User Manual)
(→"Cleaning the Printer Exterior," User Manual)