Canon imagePROGRAF iPF815 MFP M40 User Manual
Page 37
37
Error Messages
This paper cannot be used.
Paper that is too large for the
printer has been loaded.
Lift the Release Lever and load paper of the correct
size.
Paper that is too small for the
printer has been loaded.
Lift the Release Lever and load paper of the correct
size.
Paper has been loaded that is too
small to print the test pattern for
printhead adjustment or nozzle
checking.
Lift the Release Lever and load unused paper A4
or larger. More than one sheet may be required
depending on the adjustment.
Error Message
Cause
Corrective Action
(→"Paper Sizes," User Manual)
(→"Paper Sizes," User Manual)
The loaded paper is too small.
Switch to paper A4/Letter (vertical) or larger.
The loaded paper is too small.
Load a roll 10 inches wide or larger.
Cannot print as specified. Lift
the release lever and replace
paper with A4/LTR (vertical) or
larger.
Cannot print as specified. Lift
the release lever and replace roll
with 10 in. wide or larger roll.
Hardware error. xxxxxxxx-xxxx
(x represents a letter or number)
The last portion of roll paper was
used during a print job. The paper
was not advanced because the
trailing edge is taped to the roll.
Turn off the printer and remove the roll from the printer
before restoring power.
Fastening tape or the Belt Stopper
has not been removed inside the
Top Cover .
Turn off the printer, open the Top Cover and remove
the tape or the Belt Stopper before restoring power.
An error requiring service may
have occurred.
Turn off the printer and wait at least three seconds
before restoring the power.
Hard disk error.
The format of the printer's hard
disk is invalid.
Press the OK button to start reformatting the
hard disk. When formatting is finished, the printer
automatically restarts. (Formatting will erase all data
on the hard disk.)
If the message is displayed again, write down the
error code and message, turn off the printer, and
contact your Canon dealer for assistance.