Emc (electromagnetic compatibility), Precautions on emc – Canon CR-2 PLUS AF User Manual
Page 46
46
Appendix
EMC (Electromagnetic Compatibility)
The CR-2 Plus AF is designed and tested to comply with IEC 60601-1-2 (EN 60601-1-2), the applicable regulations
regarding EMC for medical devices. The CR-2 Plus AF needs to be installed and put into service according to the EMC
information stated as follows.
If this equipment causes harmful interference to other devices, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
t3FPSJFOUPSSFMPDBUFUIFSFDFJWJOHEFWJDF
t*ODSFBTFUIFTFQBSBUJPOCFUXFFOUIFFRVJQNFOU
t$POOFDUUIJTEFWJDFJOUPBOPVUMFUPOBDJSDVJUEJGGFSFOUGSPNUIBUUPXIJDIUIFPUIFSEFWJDFTBSFDPOOFDUFE
If the problem cannot be solved with the above measures, stop using this equipment and consult your sales representative
or local Canon dealer.
Precautions on EMC
1.
Medical electrical equipment needs special precautions regarding EMC and needs to be installed and put into service
according to the EMC information provided in the manual.
2.
Portable and mobile RF communications equipment can affect medical electrical equipment.
3. Information regarding the cable affecting EMC is as follows.
To maintain the optimum EMC performance, use only the designated cables.
Name
Type
Length
Remarks
AC Power Cord
Non-Shielded
3.0 m fixed-length
Supplied
USB Cable
Shielded
Max. 3.0 m
Not supplied
HDMI Cable
Shielded
Max. 2.7 m
Not supplied
4.
The use of accessories, transducers and cables other than those specified, with the exception of transducers and
cables sold by Canon sales representative or local Canon dealer as replacement parts for internal components, may
result in increased emissions or decreased immunity of the CR-2 Plus AF.
5.
The CR-2 Plus AF should not be used adjacent to or stacked with other equipment and if adjacent or stacked use is
necessary, the CR-2 Plus AF should be observed to verify normal operation in the configuration in which it will be used.