Electrolux EXI18HL1WE - Manual (Page 10)

9
Outlet pipe of
indoor unit
Vinyl tape
Outlet pipe of
indoor unit
Drain hose
Outlet pipe of
indoor unit
Drain hose (narrow)
Vinyl tape Insulating pipe
Mounting Plate Type C
Step 2: Drill Piping Hole
1 Determine hole positions according to the
GLDJUDP'ULOORQH  KROH ɎRUɎPP 
in the wall at a slight downward slant to the
outdoor side.
Piping hole Model
ɎPP &RROLQJFDSDFLW\ :
ɎPP &RROLQJFDSDFLW\!:
2 7KHLQFOLQDWLRQPXVWEHEHWZHHQPPLQ
order to ensure a good drain of condensed
water generated by the indoor unit.
Step 3: Installation of Drain Hose
Remove both
supports
3 Insert the wall pipe into the hole to prevent
and wiring from being damaged when passing
through the whole.
 Always use a wall hole conduit when drilling
metal grids, metal plates or the like.
 )RUFRROLQJFDSDFLW\RYHU:PRGHOV
remove and dispose the two polystyrene lateral
rear supports from the indoor unit before the
installation.
1 Connect the drain hose to the outlet pipe of the
indoor unit. Bind the joint with vinyl tape.
2 Put the drain hose into insulating pipe.

Indoor
Wall pipe
Seal putty
Outdoor
‘
or Ø70
5-10mm
Wall