Electrolux EXI18HL1WE - Manual (Page 19)

18
2 Take off wire cable clamp. Connect and screw
the power connection cable onto the terminal
EORFNIROORZLQJFRUUHVSRQGLQJLGHQWL¿FDWLRQ
numbers and colors on the terminal blocks of
indoor and outdoor units.
3 To prevent water from entering, make a trap
³8´ LQWKHFRQQHFWLRQZLUHV VHHSDJH 
 Wrap wires that are not connected with
insulating tape so that they do not touch any
electrical or metal parts.
 Fix the power connection wires with wire
clamps.
6 Reinstall the handle.
Blue
Black
Brown Earthing wire
(Yellow-Green)
Cable clamp
To Indoor Unit
$IWHUFRQ¿UPLQJWKHDERYHFRQGLWLRQV
prepare the wiring as follows:
‡ The screws which fasten the wiring to
the terminal block may come loose from
vibrations during transportation.
Check and make sure all screws are well
¿[HG2WKHUZLVHLWFRXOGFDXVHEXUQRXW
of the wires.
‡ %HVXUHWKHFLUFXLWFDSDFLW\LVVXI¿FLHQW
‡ Ensure the starting voltage is maintained
at over 90% of the rated voltage marked
on the nameplate.
‡ &RQ¿UPWKDWWKHFDEOHWKLFNQHVVLV
DVVSHFL¿HGLQWKHSRZHUVRXUFH
VSHFL¿FDWLRQ
‡ Always install a Residual Current Device
(RCD) in wet or moist area.
‡ The following may be caused by voltage
drop: Vibration of a contactor, which will
damage the contact point, fuse blowing,
disturbance of the normal function of the
overload.
‡ The means for disconnection from a
power supply shall be incorporated in the
¿[HGZLULQJDQGKDYHDQDLUJDSFRQWDFW
separation of at least 3mm in each active
(phase) conductor.
Step 10: Checking the Drainage
A. Open and lift the indoor unit front panel.
‡ Hold the lower part of the left and right sides
of the panel, pull it against you and lift it until a
click is heard.
caution
caution
B. Check the drainage
‡ Carefully pour a glass of water on the
evaporator.
‡ (QVXUHWKHZDWHUÀRZVWKURXJKWKHGUDLQ
hose of the indoor unit without any leakage
and goes out the drain exit.