Electrolux EXI18HL1WE - Manual (Page 14)

13
Refrigerant pipe connection
Step 5: Installation of Connection Pipe
Copper tube
Flare nut
1 Flaring work
Main cause for refrigerant leakage is due to
GHIHFWVLQWKHÀDULQJZRUN&DUU\RXWFRUUHFWÀDULQJ
work using the following procedure:
A: Cut the pipes and the cable.
‡ Use the piping kit accessory (if applicable) or
pipes purchased locally.
‡ Measure the distance between the indoor and
the outdoor unit.
‡ Cut the pipes a little longer than the measured
distance.
‡ &XWWKHFDEOHPORQJHUWKDQWKHSLSHOHQJWK
,WLVQRWSRVVLEOHWRSXWWKHPRQDIWHUÀDULQJZRUN
D: Flaring work.
‡ &DUU\RXWÀDULQJZRUNXVLQJÀDULQJWRRODV
shown below.
Handle
Bar Bar
Yoke
Cone
Pipe
Copper pipe
Clamp handle
Red arrow mark
‡ Firmly hold copper pipe in a die according to
the dimension shown in the table below.
Oblique Roughness Burr
B: Burr removal
‡ Completely remove all burrs from the cut
FURVVVHFWLRQRISLSHWXEH
‡ )DFHWKHHQGRIWKHFRSSHUSLSHWXEHLQD
downward direction as you remove burrs in
order to avoid burrs dropping into the tubing.
E: Check
‡ &RPSDUHWKHÀDUHZRUNZLWKWKHDGMDFHQW
diagram.
‡ If the pipe has any defect, cut off the enlarged
section and redo the work.
Pipe
Smooth all around
Face down
Reamer
,PSURSHUÀDULQJ
Inclined Cracked Damaged
surface
Uneven
thickness
Even length all
around
& 3XWWLQJÀDUHQXWRQ
‡ 5HPRYHÀDUHQXWVDWWDFKHGWRLQGRRUDQG
RXWGRRUXQLWWKHQSXWWKHPRQSLSHWXEH
having completed burr removal.
‡ Make an independent covering for each
pipe with the appropriate tubular isolation.
caution
Outer diam. (mm)
A (mm)
Max. Min.
Ɏ ´  1.3 0.7
Ɏ  ´ 1.6 1.0
Ɏ ´ 1.8 1.0
Ɏ ´  2.2