Electrolux EXI18HL1WE - Manual (Page 8)

7
Outdoor Unit Installation
Drain-water
hole
Drain
connecter
Chassis
Hose of inner dia. 16mm
(not provided)
Air inlet
Air inlet
Air outlet
‡ If a suspended installation is needed,
the installation bracket must allow the
¿[DWLRQDFFRUGLQJWRGLPHQVLRQVRQWKH
¿JXUHDERYH
‡ The wall where the unit will be installed
must be of solid brick, concrete or
provided with other reinforcement ways
WR¿[WKHEUDFNHW7KH¿[DWLRQRIWKH
bracket to the wall and the bracket to
WKHDLUFRQGLWLRQHUPXVWEH¿UPVWHDG\
and leveled.
‡ $QFKRUWKHRXWGRRUXQLWE\¿[LQJWKHKROHV
H[LVWHQWLQLWVEDVHGZLWKEROWVDQGQXWVRI
10 mm tightly (not included).
Place the outdoor unit over a horizontal
concrete or rigid surface (never directly over
grass or land).
Step 2: Outdoor Condensate Drainage
(only for heat pump model)
‡ During heating operation, the condensate and
defrosting water should be drained out reliably
through the drain hose.
‡ Install the outdoor drain connector in the drain-
water hole on the chassis of outdoor unit, and
attach the drain hose to the connector so that
the waste water formed in the outdoor unit can
be drained out.
‡ The drain-water hole must be plugged.
Whether to plug other holes will be determined
by the installer according to actual conditions.
‡ In case of a drain hose, the unit must be
installed on a base more than 3cm height.
Step 1: Securing of Outdoor Unit
caution
Outdoor Unit
Dimension
mm(WxDxH)
Dimension
³$´ PP
Dimension
³%´ PP
[[  286
[[   286
 [[   
[ [  368