Electrolux EXI12HD1WE - Manual (Page 19)

19
‡ After tightening the screws, pull the wire
VOLJKWO\WRFRQ¿UPZKHWKHULW¶V¿UPRUQRW
‡ Do not connect two power cables
together to supply power to the air
conditioner.
‡ 'RQRWH[WHQGWKHSRZHUFDEOHFRQGXFWRU
by cutting.
Installation of Outdoor
Electric Wires
Terminal
block
2600~5275W, Heat Pump models
1 Remove the handle on the right side plate of
outdoor unit by loosening the screw.
6450W, Heat Pump models
2 Take off wire cable clamp. Connect and
screw the power connection cable and signal
control wire (for heap pump model only) onto
the terminal block following corresponding
LGHQWL¿FDWLRQQXPEHUVDQGFRORUVRQWKH
terminal blocks of indoor and outdoor units.
3 To prevent water from entering, make a trap
(“U”) in the connection wires (see page 16).
4 Wrap wires that are not connected with
insulating tape so that they do not touch any
electrical or metal parts.
5 )L[WKHSRZHUFRQQHFWLRQZLUHVZLWKZLUH
clamps.
6 Reinstall the handle.
caution
Handle
Handle
yellow-
brown black blue
2
N(1)
3
indoor unit connection
green
Handle
yellow-
brown black blue
2
N(1)
3
indoor unit connection
green
Handle
Indoor unit connection
yellow-
green
brown
blue black
Handle
Indoor unit connection
yellow-
green
brown blue black