Electrolux EXI12HD1WE - Manual (Page 20)

20
$IWHUFRQ¿UPLQJWKHDERYHFRQGLWLRQV
prepare the wiring as follows:
‡ The screws which fasten the wiring to
the terminal block may come loose from
vibrations during transportation.
‡ Check and make sure all screws are well
¿[HG2WKHUZLVHLWFRXOGFDXVHEXUQRXW
of the wires.
‡ %HVXUHWKHFLUFXLWFDSDFLW\LVVXI¿FLHQW
‡ Ensure the starting voltage is maintained
at over 90% of the rated voltage marked
on the nameplate.
‡ &RQ¿UPWKDWWKHFDEOHWKLFNQHVVLV
DVVSHFL¿HGLQWKHSRZHUVRXUFH
VSHFL¿FDWLRQ
‡ Always install a Residual Current Device
(RCD) in wet or moist area.
‡ The following may be caused by voltage
drop: Vibration of a contactor, which will
damage the contact point, fuse blowing,
disturbance of the normal function of the
overload.
‡ The means for disconnection from a
power supply shall be incorporated in the
¿[HGZLULQJDQGKDYHDQDLUJDSFRQWDFW
separation of at least 3mm in each active
(phase) conductor.
Downward
slope
B. Check the drainage
‡ Carefully pour a glass of water on the
evaporator.
‡ (QVXUHWKHZDWHUÀRZVWKURXJKWKHGUDLQ
hose of the indoor unit without any leakage
DQGJRHVRXWWKHGUDLQH[LW
Drain hose
C. Dain piping
‡ The drain hose should
point downward for
HDV\GUDLQÀRZ
Step 10: Checking the Drainage
A. Open and lift the indoor unit front panel.
‡ Hold the lower part of the left and right sides
of the panel, pull it against you and lift it stops
with a full support from the bracket.
‡ Do not place drain piping as indicated below:
Panel
bracket
caution
Accumulated
drain water Do not rise Tip of drain
hose dipped
in water
Air
Space less
than 50mm
Water
leakage Water
leakage Water
leakage
Ditch