AT&T 1030 - Manual (Page 18)

●
●
If you want to program other buttons, repeat the two
previous steps.
Slide the T/P switch to the center position.
NOTE: If you make a mistake entering a programming code,
simply touch the button again and reenter the code.
The following feature descriptions include feature programming
codes and brief programming instructions. For example:
To program:
●
T/P to P
●
Touch the button
●
Dial *84
●
T/P to center
means slide the T/P switch to P, touch the button you want to
program, dial the programming code (in this case, *84), and
slide the T/P switch to the center position.
NOTIFY
Use the Notify feature to set up a direct messaging system with
another voice terminal. With this feature, you program a Send
button to turn on a Notify light next to the corresponding Receive
button on the voice terminal of someone for whom you often
have messages. For example, a secretary can notify his or her
boss that a message is waiting. You can program multiple Send
and Receive buttons. For each Send button you program on
your voice terminal, there must be a Receive button that has
been programmed at the receiving voice terminal, and vice
versa. Be sure to label the buttons so you can identify the per-
son notifying you or receiving your notification.
17