AT&T 1030 - Manual (Page 27)

To signal a coworker:
● Without lifting your handset, touch a Manual Signaling
button. + Signal Mary
You can also touch a Manual Signaling button to signal some-
one while you have an outside call in progress. If you program
this feature on a button with lights, the green light next to the
button goes on when your coworker uses his or her voice ter-
minal or uses the Do Not Disturb feature.
LOUDSPEAKER PAGE
If you have a loudspeaker paging system, you can make an-
nouncements using your voice terminal. Your system may have
as many as three paging zones; you can choose to make an an-
nouncement to one or all of the zones.
If you have available feature buttons, you can use the instruc-
tions below to program a button for each loudspeaker paging
zone. However, it isn’t necessary to program a button for
loudspeaker paging. You may dial a code instead.
To program:
●
T/P to P
●
Touch the button
●
Dial *91
+ a paging zone code (80=all zones,
81=zone 1, 82=zone 2, 83=zone 3)
●
T/P
to center
26