Document Outline

• Preface
• Before you Install the P332G-ML
  • Safety Information
  • FCC Notice
  • Conventions Used in the Documentation
    • CLI Conventions
    • Notes, Cautions, and Warnings
  • Warranty
  • Notice
  • Avaya Support
• Section 1: Overview
  • Avaya P332G-ML Overview
    • Introduction
    • About the P332G-ML
    • Avaya P332G-ML Highlights
    • Layer 3 Features P330-ML
    • Network Management and Monitoring
      • Device Manager (Embedded Web)
      • Command Line Interface (CLI)
      • Avaya Integrated Manager
      • Port Mirroring
      • SMON
      • Fans, Power Supply, and BUPS-ML Monitoring
  • Standards and Compatibility
    • Avaya P330 Standards Supported
      • IEEE
      • IETF - Layer 2
      • IETF - Layer 3
    • IETF - Network Monitoring
  • Specifications
    • P332G-ML Switch
      • Physical
      • Power Requirements
      • Environmental
      • Safety
      • Safety - AC Version
      • Safety - DC Version
      • EMC Emissions
        • Emissions
        • Immunity
      • Interfaces
      • Basic MTBF
    • Stacking Sub-module
      • Basic MTBF
    • Approved SFF/SFP GBIC Transceivers
      • Safety Information
        • Laser Classification
        • Usage Restriction
      • Installation
        • Installing and Removing a SFF/SFP GBIC Transceiver
      • Specifications
        • LX Transceiver
        • SX Transceiver
      • Agency Approval
    • Gigabit Fiber Optic Cabling
    • Console Pin Assignments
• Section 2: Installation
  • Installation
    • Required Tools
    • Site Preparation
    • Rack Mounting (Optional)
    • Installing the X330STK-ML Stacking Sub-Module (Optional)
    • Connecting Stacked Switches
      • To connect stacked switches:
    • Making Connections to Network Equipment
      • Prerequisites
      • Connecting Cables to Network Equipment
  • Powering Up the Avaya P330
    • Powering On - Avaya P330 Module AC
    • Powering On - Avaya P330 Switch DC
    • Post-Installation
  • Avaya P332G-ML Front and Rear Panels
    • Avaya P332G-ML Front Panel
    • Avaya P332G-ML Back Panel
      • BUPS-ML Input Connector
  • Establishing Switch Access
    • Establishing a Serial Connection
      • Configuring the Terminal Serial Port Parameters
      • Connecting a Terminal to the Avaya P330 Serial port
    • P330 Sessions
    • Assigning P330’s IP Stack Address
    • Establishing a Telnet Connection
    • Establishing an SSH Connection
    • Establishing a Modem (PPP) Connection with the P330
      • Overview
      • Connecting a Modem to the Console Port
    • Security Levels
      • Entering the Supervisor Level
        • Defining new local users
        • Exiting the Supervisor Level
      • Entering the CLI
  • User Authentication
    • Introduction
    • SNMP Support
      • Introduction to SNMP
        • SNMP Versions
        • Managers and Agents
        • Manager/Agent Communication
        • SNMPv1
        • SNMPv2c
        • SNMPv3
      • SNMP Commands
    • SSH Protocol Support
      • Introduction to SSH
      • SSH Commands
    • SCP Protocol Support
    • RADIUS
      • Introduction to RADIUS
      • Radius Commands
    • Telnet Client Support
      • Introduction to Telnet
      • Telnet Commands
    • Recovery Password
      • Introduction
      • Recovery Password Commands
    • Allowed Managers
      • Allowed Managers Introduction
      • Allowed Managers CLI Commands
    • Allowed Protocols
      • Allowed Protocols Introduction
      • Allowed Protocols CLI Commands
• Section 3: Configuration
  • P330 Default Settings
    • Configuring the Switch
      • Avaya P330 Default Settings
  • Switch Configuration
    • Introduction
      • Basic Switch Configuration
      • System Parameter Configuration
        • Identifying the system
        • Operating parameters
      • Network Time Acquiring Protocols Parameter Configuration
    • Uploading and Downloading Device Configurations and Images
      • Layer 2 Configuration File
      • Layer 3 Configuration File
    • System Logging
      • System Logging Introduction
        • System Logging Messages
        • Sinks
        • Applications
        • Syslog Servers
        • Syslog Configuration CLI Commands
    • Monitoring CPU Utilization
  • Avaya P330 Layer 2 Features
    • Overview
    • Ethernet
      • Fast Ethernet
      • Gigabit Ethernet
      • Configuring Ethernet Parameters
        • Auto-Negotiation
        • Full-Duplex/Half-Duplex
        • Speed
        • Flow Control
        • Priority
        • MAC Address
        • CAM Table
      • Ethernet Configuration CLI Commands
      • Ethernet Implementation in the Avaya P332G-ML
    • VLAN Configuration
      • VLAN Overview
      • VLAN Tagging
      • Multi VLAN Binding
      • Automatic VLAN Learning
      • Ingress VLAN Security
      • VLAN CLI Commands
      • VLAN Implementation in the Avaya P332G-ML
    • Spanning Tree Protocol
      • Overview
      • Spanning Tree Protocol
      • Spanning Tree per Port
      • Rapid Spanning Tree Protocol (RSTP)
        • About the 802.1w Standard
        • Port Roles
      • Spanning Tree Implementation in the P330 Family
      • Spanning Tree Protocol CLI Commands
    • MAC Aging
      • Overview
      • Configuring the P330 for MAC Aging
      • MAC Aging CLI Commands
    • LAG
      • LAG Overview
      • LAG CLI Commands
      • LAG Implementation in the Avaya P330 Family of Products
    • Port Redundancy
      • Port Redundancy Operation
      • Intermodule Port Redundancy
      • Port Redundancy CLI Commands
    • IP Multicast Filtering
      • Overview
      • IP Multicast CLI Commands
      • IP Multicast Implementation in the Avaya P332G-ML
    • RMON
      • RMON Overview
      • RMON CLI Commands
    • SMON
      • SMON Overview
    • Port Mirroring Configuration
      • Port Mirroring Overview
      • Port Mirroring CLI commands
      • Port Mirroring Constraints
    • Weighted Queuing
      • Implementation of Weighted Queuing in the P330-ML
      • Weighted Queuing CLI Commands
    • Port Classification
      • Overview
      • Port Classification CLI Commands
    • Stack Redundancy
    • Stack Health
      • Overview
      • Implementation of Stack Health in the P330 Family
      • Stack Health CLI Commands
  • Avaya P330 Layer 3 Features
    • Introduction
      • What is Routing?
    • Routing Configuration
      • Forwarding
      • Multinetting (Multiple Subnets per VLAN)
    • IP Configuration
      • IP Configuration CLI Commands
      • Assigning Initial Router Parameters
      • Obtaining and Activating a License Key
        • Obtaining a Routing License Key
        • Activating a Routing License Key
        • License Key CLI Commands
    • RIP (Routing Interchange Protocol) Configuration
      • RIP Overview
      • RIP2
      • RIP CLI Commands
    • OSPF (Open Shortest Path First) Configuration
      • OSPF Overview
      • OSPF CLI Commands
    • Static Routing Configuration
      • Static Routing Overview
      • Static Routing Configuration CLI Commands
      • Route Preferences
    • Route Redistribution
      • Route Redistribution Commands
    • ARP (Address Resolution Protocol) Table Configuration
      • ARP Overview
        • The ARP Table
      • ARP CLI Commands
    • BOOTP/DHCP (Dynamic Host Configuration Protocol) Relay Configuration
      • BOOTP/DHCP Overview
        • BOOTP
        • DHCP
        • DHCP/BOOTP Relay
      • BOOTP/DHCP CLI Commands
    • NetBIOS Re-broadcast Configuration
      • NetBIOS Overview
      • NetBIOS Re-broadcast Configuration CLI Commands
    • VRRP (Virtual Router Redundancy Protocol) Configuration
      • VRRP Overview
      • VRRP Configuration Example 1
        • Case#1
        • Case #2
      • VRRP CLI Commands
    • SRRP Configuration
      • SRRP Overview
      • SRRP Configuration Example
      • SRRP CLI Commands
    • Policy Configuration
      • Policy Configuration Overview
      • Policy Configuration CLI Commands
      • Policy Configuration Example
      • Policy Configuration Example
    • IP Fragmentation and Reassembly
      • IP Fragmentation and Reassembly Overview
      • IP Fragmentation/Reassembly CLI Commands
• Section 4: Troubleshooting and Maintenance
  • Troubleshooting the Installation
    • Troubleshooting the Installation
  • Maintenance
    • Introduction
    • Replacing the Stacking Sub-module
  • Updating the Software
    • Software Download
      • Obtain Software Online
      • Downloading Software
    • Download New Version without Overwriting Existing Version