HP Smart Update Manager (User Guide) - Manual (Page 10)

For information on the minimum requirements to run HP SUM, see the HP Smart Update Manager
Release Notes on the HP website:
http://www.hp.com/go/hpsum/documentation
HP SUM supported firmware for HP ProLiant servers
Supported Component
Yes System ROM
Yes, both server-based and directly to the iLO Management
NIC port iLO firmware
Yes Broadcom NIC firmware
Yes Intel NIC firmware
Yes, online NetXen NIC firmware
Yes QLogic NIC firmware
Yes PowerPIC firmware
Yes Smart Array controller firmware
Yes, some older SATA hard drives require offline mode SAS and SATA hard drive firmware behind HP Smart Array
controllers
No SAS and SATA hard drive firmware behind non-Smart
Array controllers
Yes Emulex, QLogic, and Brocade Fibre Channel HBA firmware
Yes, online only FC switch firmware
For more information on supported FC switches, see the
HP Smart Update Manager Release Notes, on the HP Smart
Update Manager Information Library at
http://
www.hp.com/go/hpsum/documentation .
Yes Tape Blade firmware
Yes, online only OA firmware
Yes, online only VC firmware
Yes CPLD firmware
Yes HP StorageWorks MDS 600 enclosure firmware
No MSA 2000 firmware (P2x00 firmware)
Yes, when attached through a Smart Array controller D2600/D2700 firmware
Yes, online only 3Gb/s and 6 Gb/s SAS BL switches
Yes FCoE/CNAs
Yes SES firmware
Deploying HP Integrity Smart Update Firmware bundles with HP SUM
You can use HP SUM to deploy components delivered with the HP Integrity Smart Update Firmware
bundles, or use HP SUM to pull updates from the web.
10 Introduction