HP Smart Update Manager (User Guide) - Manual (Page 36)

The following table shows what updates occur if WBEM switches are currently installed.
Gen8 servers G7 and earlier servers Command
WBEM WBEM no switches
WBEM and AMS WBEM /use_ams
WBEM and SNMP WBEM and SNMP /use_snmp
WBEM WBEM /use_wmi
AMS, SNMP, and WBEM WBEM and SNMP /use_ams /use_snmp
WBEM and AMS WBEM /use_ams /use_wmi
WBEM and SNMP WBEM and SNMP /use_wmi /use_snmp
AMS, SNMP, and WBEM WBEM and SNMP /use_ams /use_wmi /use_snmp
The following table shows what updates occur if AMS switches are currently installed.
Gen8 servers G7 and earlier servers Command
AMS N/A no switches
AMS N/A /use_ams
AMS and SNMP N/A /use_snmp
AMS and WBEM N/A /use_wmi
AMS and SNMP N/A /use_ams /use_snmp
AMS and WBEM N/A /use_ams /use_wmi
AMS, SNMP, and WBEM N/A /use_wmi /use_snmp
AMS, SNMP, and WBEM N/A /use_ams /use_wmi /use_snmp
NOTE: G7 and earlier servers do not support AMS.
Command-line arguments
HP SUM recognizes the following command-line arguments, which you can use to pre-populate
the GUI on the Source Selection and Review/Install Updates screens. If you specify the target and
credentials, use the /s[ilent] parameter to proceed with the installation.
You cannot use some arguments, such as /romonly and /softwareonly, together.
Description Help
Displays command line help information. /h[elp] or /?
Description Installation options
Overrides or downgrades an existing component
installation. This produces the same results as
/f:software
.
/f[orce]
Overrides or downgrades the existing installation of
components in the selected bundle. /f[orce]:bundle
Overrides or downgrades the existing installation of the
selected firmware components (applies to firmware only). /f[orce]:rom
36 Using scripts to deploy updates