HP 3PAR Application Software Suite for Microsoft Exchange - Manual (Page 124)

1. Verify that the database to restore is consistent and that it is in a clean shutdown state.
a.
Open a command prompt window.
b. Change to the ExchSrvr\Bin folder.
c. Enter the following:
Eseutil /mh YourDatabaseName.edb
d. Press Enter.
e. Note whether the State line shows as State: Clean Shutdown or State: Dirty
Shutdown
.
2. A soft recovery should be performed immediately after the virtual copy for the database is
created. If it is not performed or if the database is not consistent and the database log files
exist, use the Eseutil.exe tool to perform a soft recovery on the database and commit any
uncommitted logs to the database:
a.
Open a command prompt window.
b. Change to the ExchSrvr\Bin folder.
c. Enter:
eseutil /r rnn /ddatabase_folder_path
rnn – The log file prefix
database_folder_path – The name of the folder where the database files (.edb,
.stm ) are located
/d – Do not add a space after this switch
For example:
eseutil /r r00 /dc:\Program Files\Exchsrvr\Recovery Storage Group"
d. Press Enter.
3. Immediately after the successful completion of a repair, perform an offline defragment of the
repaired database.
a.
Open a command prompt window.
b. Change to the ExchSrvr\Bin folder.
c. Enter:
eseutil /d <YourDatabaseName.edb>
d. Press Enter.
4. Copy the .edb database files from the virtual copy to the appropriate folders that are specified
earlier when the Recovery Storage Group was created.
124 Rapid Backup and Recovery for Exchange